W11 11 Watt Course "F" continuous responsibility coils. Solenoid coils are molded with rust resistant polyester and are developed to satisfy NEMA 4 standards. These coils are water and dust tight and are supplied basic with a 1/2" NPT female nylon adapter assembly. A port assembly with an optional sign light. The coil is planned for indoor or outdoor use in basic function applications as well as those where conditions such as dust, blowing dirt or splashing water are likely to be discovered. They ought to never be immersed in water. These coils are equipped with a DIN basic adapter assembly (DIN 43650 and ISO 4400). The basic external connection is 1/2" NPT. This kind of adapter allows internal electrical connections to be made quickly while detached from the coil. The external cable connection to the housing may be organized at any one of 4 angles (90 degree increments) to assist in valve setup. The coil can be rotated to any position in relation to the valve by loosening the cap nut on top of the coil. Rotate the coil to the preferred position. Retighten the cap nut comfortably to be sure the O-rings and gasket seal appropriately. Hand tight suffices. Solenoid valves with 11 watt molded coils will certainly run in any position, nevertheless, it is recommended that they be mounted in an up-right position for optimal cycle life. Plast-O-Matic molded solenoid coils are rated for continuous responsibility up to 104 degree F ambient. Above this temperature they are rated intermittent responsibility needing a cool down duration before re-energizing. Molded solenoid coils are rated for continuous responsibility up to 104 degree F ambient. Coil surface temperature: 185 degree F. Maximum allowed ambient temperature: 104 degree F. VA Inrush: 66. VA Holding: 24. 120/60 VAC, 110/50 VAC Coil volts.
Safe operating temperature
NEMA 4 water and dust-tight enclosure
Moisture proof; fungus proof